CJ3000XT

Underlift

To print a brochure click on the images below.

  • Swan neck type configuration
  • Flat to floor loading
  • Single heavy duty lift ram c/w pilot operated check valve
  • Folding boom cylinder with power tilt and pilot operated check valve
  • Hydraulic boom extension c/w pilot operated check valve
  • Lift bar c/w L arms
  • Sliding ratchets and straps
  • EN24T hardened and tuffrided Æ 70mm paddle pivot pin with spheroidal graphite flange bearings
  • Lift capacity - 1900KG at maximum extension
  • All hydraulic cylinders with stainless steel rods
  • All articulation bearings Glacier Du bearings Main boom painted in 2 pack acrylic red
  • Outer and inner boom and paddles colour zinc passivated

 

Hydraulics

  • PTO and gear pump cable operated c/w buzzer
  • 35lt hydraulic oil tank c/w tank top filter, filler breather and suction strainer
  • 4 function valve block with direction control ceetop valves  
  • 8 Function pendant hard wired to control panel 5m lead
  • All hydraulic pipework wire braided rubber hoses

 

Subframe

  • Full length chassis subframe

 

Locker System

  • 3 piece monococque shell with anti-vibration rubber mounts to subframe
  • Manufactured from 2.0mm cold reduced mild steel sheet
  • 1 No cross locker
  • 2 No side lockers
  • 1 pair stand alone toolboxes
  • Air vents to locker
  • Gas struts to all doors
  • Stainless steel hinges
  • Stainless steel rotary tee handles
  • Rubber door seals
  • Plastic cushion floor matting
  • Bridge style flyer
  • Mitred back panel with separate flush fitting light units
  • Footstep and grab handle
  • All joints seamsealed
  • Underside undersealed
  • Interior painted in hammer silver finish
  • Exterior painted in 2 pack acrylic to match cab

 

Electrical

  • 4 rotator beacon to flyer c/w illuminated centre
  • Stop/tail/brake lights switching from cab
  • 2 No work lights mounted to top of crosslocker
  • 2 No lower skirt mounted loading lights
  • 2 No locker lights switched from control housing
  • Emergency stop system to underlift and winch
  • 7 pin socket to rear (compatible with vehicle electrics)

Winches

  • Ramsey HDP 8000lb hydraulic winches
  • Ø10mm x 23m Wire rope
  • Rotating head sheaves

 

Standard Accessories

  • 50mm Tow ball attachment
  • Low winch pulley

 

Options Available

  • Twin HDP 8000 hydraulic winches c/w twin rotating head sheaves
  • Hydraulic top boom
  • Hydraulic rear stiff legs

 

Options available on request